Deprecated: Function create_function() is deprecated in /home/customer/www/ on line 49
Servotronix Israel - What may cause premature failure of ball screws?

Not from Israel?

Visit our global website:

Deprecated: The each() function is deprecated. This message will be suppressed on further calls in /home/customer/www/ on line 2236
What may cause premature failure of ball screws?

Deprecated: parse_str(): Calling parse_str() without the result argument is deprecated in /home/customer/www/ on line 141
Responses (1)
  • Accepted Answer

    Monday, May 26 2014, 03:30 PM - #Permalink
    Premature failure may be caused by any of the following:

    A) Misalignment of the ball nut to screw which results in side loading or eccentric loading will reduce life. This may cause the bearing balls to split or get flats on them. The bearings may even break out of the tubes.

    B) Metal chips or dirt in the ball nut will not allow the bearings free circulation. The bearing balls may get flats on them because of skidding and spalling.

    C) Lack of lubrication: Proper lubrication will help dissipate heat and reduce metal-to-metal wear of components.

    D) Excessive speed: Exceeding the ball nut critical speed can break pickup fingers off causing the balls to come out of the nut. Exceeding the screw critical speed will cause the screw to whip or vibrate and cause misalignment. Shaft speeds resulting in screw surface speeds above 8,000 IPM will reduce rated life.
    The reply is currently minimized Show
Your Reply